Questions? Feedback? powered by Olark live chat software

Installation

End Launch Connectors - Installation Procedure

end-launch-installation-diagram-1.png

Step 1: Mount the end launch connector on the board in the desired position.

Step 2: Ensure the launch pin is centered on the trace.

Step 3: Ensure the transition block is tight against the board.

Step 4: Tighten the 1-72 mounting screws until the connector is secured.

Step 5 (Optional) : Solder the launch pin to the trace. (Note: Be sure the solder flows the entire length of the launch pin/trace contact area.)

Step 6 (Optional) : Remove any excess solder. (Note: Excess solder will affect performance.)

Step 7 (Optional) : Clean any flux or other residue from around the solder joint.

 

end-launch-installation-diagram-2.png

end-launch-installation-diagram-3.png

 

____________________________________________________________________________________


 

There are no products listed under this category.

Welcome to HASCO Components precision RF and Microwave coaxial cable assemblies section. HASCO stocks an extensive selection of standard length Semi-Rigid, Hand Formable and Flexible Low Loss, Ultra Low Loss, Phase Stable vs. Flexure, Phase Stable over Temperature, Amplitude Stable, Precision Bench Test, VNA, and Armored coaxial cable assemblies. HASCO's RF and Microwave cables are terminated with high quality precision SMA, 3.5mm, 2.92mm, 2.40mm and 1.85mm male (Plug) and Female (Jack) connectors. In addition to the standard length in stock, HASCO builds custom cable assemblies with SMA, SSMA, 2.92mm, 2.40mm, 1.85mm, 1.0mm, Type N, TNC, GPO™ and GPPO™ connectors.

Complete your order by 4:00 p.m. PST and receive same-day shipping. Don’t forget to sign up for HASCO’s newsletter to receive up-to-date deals and new RF cable assembly product releases!